V1.30.730
I am a bit disappointed this has not been resolved. It has been going on with every version of Speccy since I built this system in Oct 2015.
Speccy reports:
+3.3V 2.028 V
+5V 3.367 V
+12V 0.048 V
CMOS BATTERY 1.524 V
If my PSU was outputting those voltages, this computer would not be running.
Note HWiNFO reports:
+3.3V 3.305 V
+5V 5.010 V
+12V 12.168 V
VBAT 3.048V
Those voltages are right in line with my multimeter readings. Since other HW monitors report correct voltages, it is not the sensors. I must be Speccy.
And note I have seen this on several computers. And sadly, I have seen where forum posters, concerned about those voltages, have wasted their money buying new power supplies that were not needed. It is for this voltage reading alone that I often recommend other hardware monitors/system information programs to people instead of Speccy even though Speccy otherwise, is a great program.